intel processor diagnostic tool doesnt run

After doing so, go to Network Setup > TCP/IP Settings > Wired LAN IPV4 Configuration, disable DHCP Mode, and fill out the information for your static IP address. Select Network Setup > Intel ME Network Name Settings and enter your host name in the Host Name text box. Next, select SOL/Storage Redirection/KVM and enable Storage Redirection and KVM Feature Selection.

To use a static IP address, select Intel AMT Configuration > Manageability Feature Selection, then select Enabled. Afterward, select MEBx Login and log in as admin with the password that you just set.ĪMT can use either a static or DHCP IP address. Once you have set the password, you can then reboot the system by pressing Ctrl and P keys once more. It will then prompt you to set a new password (must be at least eight characters long, contain at least one upper case character, one number, and one special character it cannot contain any Unicode character). Doing so will bring you to the Management Engine BIOS Extension (MEBx) Login screen, which will ask you for the default admin password (admin). Initiate a reboot of the system, and while the system is booting up, again press the Ctrl and P keys. To enable AMT, press Esc while the system is booting up, and navigate to Advanced > AMT Configuration.įrom this screen, enable Intel AMT, save the settings, and then exit the BIOS setup. AMT works by using a small secondary processor located on the motherboard, and you can connect to a system running AMT by using a variety of tools.

Over the years, Intel has added a wide range of features to AMT, including remote KVM, remote media mounting, time-based wake up, and event log viewing. The first widely available version of Intel AMT was released in 2007.

Intel processor diagnostic tool doesnt run